 The 8630C accelerometers meet requirements
for modal analysis. The light weight, five gram design reduces mass loading on light structures, especially when multiple
units are used. This sensor feature high sensitivity and high thermal rejection. Type 8630 accelerometers are housed in a
hard anodized, environmentally sealed housing. The finish provides ground isolation as well as environmental protection. Type
8636C is designed for stud mounting. The patented PiezoBEAM design features outstanding phase reponse as well as a wide
frequency range. The sensor is available in three ranges with sensitivities as high as 1000mV/g.
The built-in
charge amplifier provides a low impedance voltage output, allowing use of low cost, standard cabling. These sensors will
operate directly from the internal power source, available in most FFT analyzers or from Kistler's large selection of
power supply couplers. The sensor can be connected with a common coaxial cable such as Type 1761B.
• Low impedance, voltage mode
• High sensitivity
• Very low noise, dynamic range >90dB
• Small transverse sensitivity
• Ground isolated
• Conforming to CE
Kistler
Models 8630C & 8636C PiezoBEAM® Accelerometers
|
