p-T-Sensor for mold cavity pressure up to 2000 bar and contact temperature in the cavity when injection molding plastics.
Design without diaphragm but with flat front.
The p-T-Sensor Type 6190A for mold cavity pressure and temperature
has a front diameter of 4 mm. The pressure acts over the entire front of the sensor and is transmitted to the quartz
measuring element, which produces a proportional electric charge which is converted into a voltage in the amplifier and
is then available at the amplifier output.
The contact temperature of the melt is measured on the front of the
sensor by one pair of thermocouples, type K (NiCr-Ni). The sensor front can therefore not be machined. This product
complies with CE standard 89/336/EEC.
• Suitable for industrial use
• Measures pressure and temperature
p-T-Sensor for mold cavity pressure up to 2000 bar and contact temperature in the cavity when injection molding plastics.
Design without diaphragm but with flat front.
